ABB090 is made from high grade alloyed, cold rolled, phosphorous tin bronze.
The slide bearings are especially designed to withstand heavy loads and to be shock-resistant.
The entire bearing sliding surface consists of lubrication pockets that build up a lubricating film that reduces friction, both at startup and during operation. ABB090 is intended for
radial, oscillating and axial movements and are especially suited for extra high loads. ABB090 take over where other types of bearings break or fail.
The bearings are intended to be pressed into a housing with H7 tolerance.
The inner diameter of the slide bearing will then hold tolerance H9.
Axle/shaft – Bearing play
To the H9 tolerance of the slide bearing we recommend shafts with tolerance e7 or f7. If h-shafts are used, the bearing inner diameter should be machined up to tolerance F7.
Lubrication should be done through the shafts or radial through the housings. All common
grease-types or oil can be used.
We can offer special sizes, shapes, forms or lengths upon request.
Please contact us for a quotation or more information.
|Material:||Cu â€“ 91.3% Â Â Sn â€“ 8.5%Â Â Â P â€“ 0.2%|
|Standard:||Cu Sn8. DIN 17662. CW453K|
|Sliding layer (thickness):||Homogeneous|
|Tensile strength Rm:||450N/mmÂ²|
|Yield strength Rp 0.2:||300N/mmÂ²|
|Elongation in % A10:||0.2|
|Max. load static:||150 N/mmÂ²|
|Max. load, dynamic:||60 N/mmÂ²|
|Max. sliding speed (w.lubr.):||2.5 m/s|
|Pv-value, Mpa x m/s, kont / int:||2.8|
|Recommended shaft hardness:||>277HB|
|Rec. shaft surface roughness (Ra)||1.6|